RandallNoll
11-19-2009, 04:02 PM
We designed the Data Module to be able to use any 0-5v sensor in the 'SENS' input. Because of that, we couldn't hard-code DashWare to mate that signal to a specific gauge spot (Throttle, Temp, Boost, etc.). In order to setup the sensor to be used you should do the following.
NOTE: This only needs to be done once. From then on you will have this sensor automatically mapped.
Youtube video showing this process here: http://www.youtube.com/chasecam#p/a/u/0/S52TRAWR_-A
1. Open up the Data Profile Editor (File / Edit Data Profiles)
http://www.chasecam.com/files/images/dashware_data_profiles/1_600.jpg
2. Select the "ChaseCam (Read Only)" data profile at the top and click the Clone button to make a copy of it. Save the copy with a new filename.
http://www.chasecam.com/files/images/dashware_data_profiles/2_600.jpg
3. In the lower left, add a new Calculator by clicking on the '+' sign. Choose "Linear Interpolator" and click Add.
http://www.chasecam.com/files/images/dashware_data_profiles/3_600.jpg
4. Make the Input Value "mV" and choose a name for the sensor you have hooked up (ex: Throttle Position).
http://www.chasecam.com/files/images/dashware_data_profiles/4_600.jpg
5. In the lower right, add a new Column Mapping by clicking on the '+' sign. Name the Input Data Column the same name you used in step 4. Then choose the Data Category and Type to associate the sensor with.
http://www.chasecam.com/files/images/dashware_data_profiles/5_600.jpg
This should do it. Now you can use your new data profile when you open your data/video files and everything will be connected.
Thanks.
NOTE: This only needs to be done once. From then on you will have this sensor automatically mapped.
Youtube video showing this process here: http://www.youtube.com/chasecam#p/a/u/0/S52TRAWR_-A
1. Open up the Data Profile Editor (File / Edit Data Profiles)
http://www.chasecam.com/files/images/dashware_data_profiles/1_600.jpg
2. Select the "ChaseCam (Read Only)" data profile at the top and click the Clone button to make a copy of it. Save the copy with a new filename.
http://www.chasecam.com/files/images/dashware_data_profiles/2_600.jpg
3. In the lower left, add a new Calculator by clicking on the '+' sign. Choose "Linear Interpolator" and click Add.
http://www.chasecam.com/files/images/dashware_data_profiles/3_600.jpg
4. Make the Input Value "mV" and choose a name for the sensor you have hooked up (ex: Throttle Position).
http://www.chasecam.com/files/images/dashware_data_profiles/4_600.jpg
5. In the lower right, add a new Column Mapping by clicking on the '+' sign. Name the Input Data Column the same name you used in step 4. Then choose the Data Category and Type to associate the sensor with.
http://www.chasecam.com/files/images/dashware_data_profiles/5_600.jpg
This should do it. Now you can use your new data profile when you open your data/video files and everything will be connected.
Thanks.